For up-to-date information about the Coronavirus in the Amarillo area, please visit


Sealcoat Process

Press Enter to show all options, press Tab go to next option

Step 1 - Crack Sealing

Approximately midway through the ten year sealcoat cycle an emulsified asphalt sealant material is poured into any visible crack in the pavement.

Step 2 - Repair Work

Prior to sealcoating streets any structural damage to the street will be repaired by City crews.

Step 3 - Door Hangers

About a week before a street is to be sealcoated, the Street Division will place door hangers on the front door of all residences that front on that street.

Step 4 - Power Brooming

Within 24 hours before the liquid asphalt and rock are applied, the streets are swept off to remove loose materials and debris that could inhibit the asphalt from sticking to the pavement surface

Step 5 - Flagmen

Prior to the street being treated, safety flagmen are positioned at key points along the route to direct traffic and maintain a safe work zone for the public and the workers.    For your safety and the protection of your vehicle, carefully follow the directions of the Flagmen.

Step 6 - Application of Liquid Asphalt

A thin layer of hot liquid asphalt is sprayed on the pavement surface.

Step 7 - Application of Pre-coated Rock

Immediately following the application of the liquid asphalt, a piece of equipment called a "chipspreader" evenly distributes the pre-coated rock over the liquid asphalt area. The chipspreader has the ability to control the amount of rock being released to minimize waste. The chipspreader is large and bulky by itself, but driving the chipspreader is a challenge when a dump truck full of rock is attached to the back of the chipspreader. For this reason, you are asked to move any vehicles you may have parked in the street.

Step 8 - Rolling

Once the pre-coated rock is applied to the liquid asphalt, a couple of "rubber-tired rollers" will drive back and forth over the rock to press the rock securely into the liquid asphalt. The rubber-tired rollers are very heavy and apply a great deal of pressure to the road surface to accomplish this task.

Step 9 - Power Brooming

Usually, the following day a power broom will return to sweep the loose rock over to    the sides of the street.  This slow moving vehicle will make multiple passes up and down a street to remove the loose rock from the primary travel path of the street and  to move the loose rock to an area where the street sweepers can readily pick it up and to minimize traffic disruption.

Step 10 - Street Sweeping

About one week after the streets are power broomed, a street sweeper will be scheduled to come by and pick up the loose rock that  accumulated along the sides of the street.